Crown FMX250 Manuale Utente Scaricare il pdf (Pagina 14)

2–6

Installation

4) Locate the cable assembly with the "N" type connectors that are connected 

together with a "N" style Female "T". Each of the ends of this assembly 

should connect to the "RF Input" located on the back panel of each PA. This 

cable is RG-11 type and is labeled as such. See Illustration 2-8 for location of 

RF Input. The center of this assembly should have an open female "N" 

connector. Locate the 3 foot RG-214 cable (labeled 101635-1) and attach it 

between this point and the RF output of the FMX250. Refer to Illustration 4-3 

on page 4-3 of section 4 for further information.

Illustration 2-8 I/O port locations

Back of 

Power Amp

Back of 

Transmitter 

Controller

DB-25 I/O port

RF Input

3) Locate the DB-25 Male-to-Male cables and connect between 'I/O' port on 

both of the PA's and the ports labled PA1 and PA2 on the Transmitter 

Controller with the top PA going to PA1. The I/O ports and PA input ports 

for each is shown in Illustration 2-8.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 43 44

Nessun commento

Crown FMX250 Manuale Utente Pagina 14